[olug] network configuration

[Vincent]

What card(s) do you have installed?
What's the output from the following commands?:

lsmod
dmesg | grep -i eth


Nathan Brown wrote:
> 
> I cannot get my redhat 7 to configure the eth0 from a hard disk boot.
> If I boot with the floppy eth0 sets up fine and I can use the network.
> When I boot with the harddisk there is a message that it's delaying the
> initialization of eth0 .. .... So, I go into linuxconf or netcfg and try
> to set it up and it tells me the same thing ... delaying the
> initialization of eth0.
> 
> Any Ideas?
> 
> Thanks
> Nate
> ps when I install S.U.S.E. from the hard drive it works fine too.
> and in redhat there is also a failure to load some modules (I did not
> think pertinent) that seem to have something to do with something else
> ....
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: olug-unsubscribe at bstc.net
> For additional commands, e-mail: olug-help at bstc.net

---------------------------------------------------------------------
To unsubscribe, e-mail: olug-unsubscribe at bstc.net
For additional commands, e-mail: olug-help at bstc.net